National Hotline
Products Products
Hot Products / Application
Contact Us
Contact Us
Tel: +86-21-50373416 50373296
Add: Suite 501,Buildig C2,No.1599 Xin Jinqiao Road,Pudong District,Shanghai 201206 China
3D Analysis Software    Leave the Plane: 3D is much more than 2D    The image analysis software Mov3D offers you the possibility to analyze 3D motion of dynamic recordings.    For this you track objects in several different stereoscopic views with the module MovXact, Subsequently the 3D curves are calculated based on photogrammetric methods.     Main features     Easy management of multi views within one test file    Interface to 3D control points    New type of marker CODE (= coded ring marker, by AICON)    Calculation of camera position using known control points    Calibration of camera and lens with powerful distortion correction.    (Use drag&drop from module CamFolder)    3D calibration and output of x-y-z displacement/time diagrams    (with a-v differentiation etc. see MovXact)     Data necessary for successful 3D analysis:  control point data  Tracking data: control points and unknown points  image sequence  (per view)   Calibration measurements  image sequence of test target +  camera - lens - data  (per camera)+  control point data in ASCII file     ► Position measurements  3D control points with tracking data +  calibration measurement  (per view + per image)  ► 3D measurements  tracking data of unknown points +  calibration measurements +  position measurements  ( n * 2D → 3D    Pre-conditions for 3D measurements   At least two views from different points are included in the analysis session.   (Same) control points and marker targets with the same name are setup and measured in the single views.   All cameras run synchronously (as possible within 1 line)   The frequencies of the image sequences need to be equal or    integer parts of the maximum occurring frequency = max. frequency / n.   The T0 start times should be in the raster of the maximum image frequency:   T0(n) - T0-min. = 1 / max. frequency.   The camera positions are calculated within the overlapping time interval; for this measurement data of at least 4 control points per image are necessary. Alternatively the positions may be defined as „static“.   A triangulation on the basis of the measured image coordinates must be possible.   Own scales or rulers are not necessary for calibration.   The scaling is implicitly included in the control point information.
  • 威测二维码
    VTS WeChat Public Number
Contact Us
Add: Suite 501,Buildig C2,No.1599 Xin Jinqiao Road,Pudong District,Shanghai 201206 China
Hotline:+86-21-50373416 50373296
分享 QQ 微信 新浪
Copyright ©2005 - 2019 Shanghai Vehicle Test System Ltd.